The use of plant fibres as reinforcement in composite materials is finding increasing interest in the automotive and building industry, and the properties of plant fibre composites have been addressed in numerous research studies. The replacement of synthetic fibres with natural fibres in composites is based on their renewable and environmentally friendly nature.
The aim of this work is to investigate the effects of two chemical pre-treatment methods on the water absorption property of polyester-fibre composites. Fully grown kenaf (hibiscus cannabalis) bast fibres were manually retted from the stalk, washed, and cut into short fibre lengths of about 10 cm. One portion of the fibres was pre-treated with 5% pbw NaOH solution before immersing it in glacial acetic acid and then in acetic anhydride. The second portion was pre-treated with 5%pbw of NaOH and 0.125% of KMnO4 in acetone. The third portion of fibres was untreated to serve as control. The ground fibre was incorporated into ortho unsaturated polyester and cast with Teflon square shaped mould. The cured samples were weighed and immersed in water at room temperature until no further gain in weight was observed. The SEM of the fibres and the composites was taken. The results showed that the acetylation pre-treatment method reduced the water absorption property of the composites by a minimum of 46.0% across all fibre volume fractions while the permanganate pre-treatment reduced it by at least 25.5%. Chemical pre-treatment of fibres can therefore
B. O. Madsen, “Properties of plant fibre yarn polymer composites an experimental study,” Ph. D dissertation, Dept. BYG-DTU 2004
Y. J Weitsman, “Effects of Fluids on Polymeric Composites – A Review,” in Comprehensive Composite Materials (6 vols), vol. 2, A. Kelly and C. Zweben, Ed. Elsevier Science. Vol. 2, 2000, pp. 369-401.
L. Menachem, Handbook of natural fibres, Boca Raton FL, CRC Press, Tailor and Francis,2007, pp 420 – 450.
V. A. Alvarez, A. N. Fraga and A. Vázquez. “Effects of the moisture and fiber content on the mechanical properties of biodegradable polymer-sisal fiber biocomposites,” Journal of Applied Polymer Science, vol. 91, pp. 4007-4016, 2004.
S. Avramidis, “The basics of sorption,” Proceedings of An International Conference on Wood-Water Relations, ed, P. Hoffmeyer, pp. 3-16, Copenhagen, Denmark, June 1997.
S. J. Barton and G. Pritchard, “The moisture absorption characteristics of cross-linked vinyl terminated polyethers compared with epoxies,” Polymers for Advanced Technologies, vol. 5, p. 245-252. Wiley, New York, USA, 1994.
L. H. Estrada, S. Pillay and U. Vaidya, “Banana fibre composites for automotive and transportation application”, in GPEC, SPE Conf Proceedings, 2008.
S. Mishra, J.B Naik and Y.P Patil “Reinforced novalac composites,” Composite science Technology, vol. 60, pp. 17- 29, 2000.
L. Salmén, “The Sorption Behaviour of Wood,” Proceedings of An International Conference on Wood-Water Relations, ed, P. Hoffmeyer, pp. 33-34, Copenhagen, Denmark, June 1997.
This work is licensed under a Creative Commons Attribution 4.0 International License.
The names and email addresses entered in this journal site will be used exclusively for the stated purposes of this journal and will not be made available for any other purpose or to any other party.
Submission of the manuscript represents that the manuscript has not been published previously and is not considered for publication elsewhere.