Effect of Turbine and Compressor Inlet Temperatures and Air Bleeding on the Comparative Performance of Simple and Combined Gas Turbine Unit

##plugins.themes.bootstrap3.article.main##

  •   Basharat Salim

  •   Jamal Orfi

  •   Shaker Saeed Alaqel

Abstract

The proper utilization of all the available forms of energy resources has become imminent to meet the power requirement and energy demand in both the developed and developing countries of the world. Even though the emphasis is given to the renewable resources in most parts of the world, but fossil fuels will still remain the main resources of energy as these can meet both normal and peak demands. Saudi Arab has number of power plant based on natural gas and fuel that are spread in all its regions. These power plants have aeroderivative gas turbine units supplied by General Electric Company as main power producing units. These units work on dual fuel systems. These units work as simple gas turbine units to meat peak demands and as part of combined cycle otherwise. The subject matter of this study is the performance of one of the units of a power plant situated near Riyadh city of Saudi Arab. This unit also works both as simple gas turbine unit and as a part of combined cycle power plant unit. A parametric based performance evaluation of the unit has been carried out to study both energetic and exergetic performance of the unit for both simple and combined cycle operation. Effect of compressor inlet temperature, turbine inlet temperature, pressure ratio of the compressor, the stage from which bleed off air have been taken and percentage of bleed off air from the compressor on the energetic and exergetic performance of the unit have been studied. The study reveals that all these parameters effect the performance of the unit in both modes of operation.


Keywords: Energetic Efficiency, Exergetic Efficiency, Aeroderivative Turbines, Air Bleeding, Compressor Inlet Temperature, Turbine Inlet Temperature

References

Jabber, J.O, Mohsen, M.S, Probert, S.D., Alees, M., "Future Electricity Demands and Greenhouse Gas Emissions in Jordan" Applied Energy, 2001, Vol. 69, 1-18.

Najjar, Y. S. H., "Enhancement of Performance of the Gas Turbine Engines by Inlet Air Cooling and Cogeneration System" Applied Thermal Engineering, 1996, Vol. 16, 163-173.

Jabber, J. O, "Greenhouse Gas Emissions and Barriers to Implementation in the Jordanian Energy Sector" Energy Policy, 2002, Vol. 30, 385-395.

Abdurrahman, M. A and Abdulhadi, V. “A Review of Inlet Air Cooling technologies for Enhancing the Performance of combustion Turbines in Saudi Arabia” Applied Thermal Engineering, 2010, 30 1879-1888.

Dixon, S. L. and Hall, C. A. “Fluid Mechanics and Thermodynamics of Turbomachines” 6th Edition, Butterworth- Heinemann, 2010.

Alhazmy, M. M. and Najjar, Y. S. H., "Augmentation of Gas Turbine Performance Using Air Coolers" Applied Thermal Engineering, 2004, Vol. 24, 415-429.

Amel, F. Cadavid, J., "Influence of the Relative Humidity on the Air Cooling Thermal Load in Gas Turbine Power Plant (2002)" Applied Thermal Engineering, 2002, Vol. 22, 1529-1533.

4 Al-Bortmany, J. N. “Assessment of equa-amonia refrigeration on pre-cooling gas turbine inlet air” Proceedings ASME TURBO EXPO 2002, Amsterdam, Netherland, June 3-6, 2002.

Jaber, J. O., Badran, O. O, and Abu-Shikhah, N., "Sustainable energy and environmental impact: role of renewables as clean and secure source of energy for the 21st century in Jordan". Clean Technologies and Environment Policy, 2004, Vol. 6, 174-186.

Franco, A. and Casarosa, C., “Thermo- economic Evaluation of the Feasibility of the Highly Efficient Combined Cycle Power Plants” Energy, 2004, 29, 1963-1982

Villella, I. A. C and Silveira, J. “Ecological Efficiency in Thermoelectric Power Plants” Applied Thermal Engineering, 2007, 27 840-847.

Godoy, E., Scenna, N. J. and Benz, S. J. “Families of Optimal Thermodynamic solutions for the Combined Cycle Gas Turbine (CCGT) Power Plants” Applied Thermal Engineering, 2010, 30, 569-576.

Ogaji, S.T, “computer Simulation model for Industrial Gas Turbine Performance”, Master Thesis, Department of Mechanical Engineering, river State University of Port Harcourt Press, Port Harcourt. (1997).

Pankaj, K.P, “Better Power Generation from Gas Turbine along with Improved Heat rate”, Proceeding of the 2003 Powergen international Conference, Atlanta, 1(3), pp1-6.

Somkiat, B. and Pichia, N. “Exergy Evaluation of the EGAT Combined Power Plant, Proceedings of the 2004 Joint Conference on Sustainable Energy and Environment, Hua Hin, 4(4), pp 1-5.

Mohamad, J.E. and Mofid, G. B., “Exergetic Analysis of Gas Turbine Power Plants, International Journal of Energy, 2005, 2(1) pp 31-39.

Nasser, M. J. “Exergy Analysis and Second Law Efficiency of Regenerative Brayton Cycle with Isothermal Heat, Technical Paper, Entropy Pub, Amman Jordan, 7(3), pp 172-1787, 2005.

Kamal, N. A. and Zuhair, A. M., “Enhancing Gas turbine output through Inlet Air Cooling” Sudan Engineering Society Journal, 52(46), pp 1-8, 2006.

Tamer, Y., “Performance Optimization of Gas Turbine Based Cogeneration System, Journal of Physics, 39 (11) pp 2454-2458, 2006.

Sanjay, O, Muku, A. and Rajay, Y., “Energy and Exergy Analysis of Brayton – Diesel cycle, Proceedings of the 2009 world Congress on Engineering, London, 2(1) pp 1-6.

Ashok, K., Kachhwaha, S. S. and Mishra, R. S. “Thermodynamic Analysis of a Regenerative Gas Turbine Cogeneration Plant, Journal of Scientific and Industrial Research, 2010, 69(1) pp 225-231.

Rosen, M. a. and Dincer, I., “Exergy as Confluence of Energy, Environment and Sustainable Development” Exergy International Journal, 1(1) pp 3-13 2001.

Haseli, Y., Dincer, I. and Naterer, G. F., “Unified Approach to Exergy, Efficiency, Environment Impact and Sustainable Power Development for Standard Thermodynamic Cycles” International Journal of Green Energy, 5, 105-119, 2008.

Saleh, S.B., Jamal, O. and Ansary, H. “Impact of ambient conditions of Arab Gulf countries on the performance of gas turbines using energy and exergy analysis” Applied Thermal Engineering, 138, 417-432.

Abam, D.P.S. and Moses, N.N., “Computer Simulation of a Gas Turbine Performance” Global Journal of Researches in Engineering, Volume 11, Issue 1, 2011.

Saravanamuttoo, H.I.H, Rogers, G.F.C and Cohen, H., (2001) “Gas Turbine Theory” 5th Edition, Pearson, Prentice Hall, London,2001.

Downloads

Download data is not yet available.

##plugins.themes.bootstrap3.article.details##

How to Cite
[1]
Salim, B., Orfi, J. and Alaqel, S.S. 2020. Effect of Turbine and Compressor Inlet Temperatures and Air Bleeding on the Comparative Performance of Simple and Combined Gas Turbine Unit. European Journal of Engineering and Technology Research. 5, 12 (Dec. 2020), 39-45. DOI:https://doi.org/10.24018/ejers.2020.5.12.2276.